TREVOLI - DSK-1 Electronic Pump Controller

Automatic Electronic Pump Controller

Model: TREVOLI DSK-1

Auto restart available with the 2.2 bar cut in controller, this will auto restart the pump once every 24 hours, ideal for batches or cast iron pumps.

This controller is used to automatically control the functioning of electric water pumps. It can guarantee the optimum control of electric pumps used in plumbimg systems. Being an intelligent mix of hydraulic and electronic engineering, the control maintains both pressure and flow and controls the operation of the pump automatically. It needs no pressure tank as in the traditional systems. There are no plenum chambers to recharge and no irritating variation in pressure and in flow at the point of use. No adjustment or maintenance is required. It is absolutely dependable, durable and simple to install.

Functioning:

The unit is programmed to perform all the pump control operations automatically. When particular operational breakdowns occur, such as water failure, obstruction of the suction pipe, etc, the unit recognizes the breakdown and a red LED Failure lights up, at the same time a stop signal is sent to the pump to prevent damage caused by it working in the absence of water. After rectifying the cause of the failure the system to be restarted by pressing the Reset button. 

Specifications:

* Rated Voltage:220V-240V
* Max.Current:10A
* Frequency:50 HZ
* Max.Power:1.5KW
* Joint Screw:1inch (25mm)
* Protection Grade:IP65

This controller comes Pre-wired. It has a standard 3 pin plug for the mains and a 3 pin receiver which allows for a 3 pin plug from the pumps motor to connect directly in to the controller.

DSK Brochure