CM2-60E - Domestic Stainless Steel Multistage Water Pump - 1 HP

HiFlo CM2-60E - Stainless Steel Multistage Water pump fitted with Electronic controller

Specs:
Power -750W - 1 Horsepower
Single phase with standard NZ 3 pin plug
Max Flow rate: At 70 litres per minute
2900 rpm
Max Pressure:81 psi
Max discharge head: 56 metres
Inlet size: 1 inch BSP (same as 25mm)
Outlet size: 1 inch BSP (same as 25mm)
Built in thermal overload protection
Insulation class F
IP55 Protection
Rated for Continuous duty
Liquid temperature range: -15 - 70 deg C
Max operating pressure: 10 bar
Number of Impellors: 6
Length: 398mm
Height: 210mm
Width: 133mm

Common Applications:
Domestic water supply for large / very large homes
General water transfer systems
Industrial/commercial applications

Features:
* Fitted with an electronic automatic constant pressure control system (provides constant pressure at constant flow)
* Starts automatically when the tap is turned on (and pressure drops to 2.2 bar)
* Operates constantly from low flow to full flow
* Stops automatically when the last tap is turned off
* Run Dry Protection
* Corrosion resistant stainless steel construction
* Stainless steel pump housing
* Stainless steel motor shaft
* Stainless steel impellor and intermediate chambers
* Japanese bearings
* Built in thermal overload protection
* Very quiet operation

Performance
This is a High pressure Pump - up to 81 PSI, supports up to 7 taps operating at one time. (Based on 10 L/m).
At 42m Head flow rate = 33 litres per minute

2 Year back to base warranty