Hot Water Booster Pump

Power -80W
220 - 240V with standard 3 pin plug
Max Flow rate: 26 L/m
Max discharge head: 8.5 metres
Inlet/Outlet sizes: 20mm / 3/4"
Max Fluid temperature range 0-60Deg C

Model: developed for domestic use in homes where inconsistent or low hotwater pressures cause problems, especially in bathrooms and laundries.

These extremely quiet pumps have particular application in homes equipped with gravity fed hot water system, or simply in situations where low water pressure is experienced.

The JCR hot water booster pump can be easily installed to new pipework or existing pipework. The pump increases the water pressure so that the flow rate is comfortably high in showers, taps and any other domestic water outlets. A built-in flow switch starts and stops the pump when the tap is turned on and off.

When used to boost hot water, the pump will assist in minimising the often annoying change of shower water temperature when someone else at home uses another hot water outlet. Furthermore, there is much less waiting time
for hot water to appear in the shower or other water outlet when the hot tap is turned on.

In the case of a gravity fed hotwater system, the in-line designed pump is typically installed along the 3/4"copper pipe under the roof that runs between the hotwater tank and the shower or tap outlet.

Features:
* Very quiet operation
* Low power consumption
* Pump Body- FC200 cast iron

- Impeller: Glass Reinforced plastic

- Pump shaft: Ceramic

- Stainless steel canned rotor type

- 1 year warranty